What a bar bender does, and how the wage is set
Bar benders, also called steel fixers, cut, bend and tie reinforcement steel to the bar-bending schedule before concrete is poured. Reading drawings and getting the laps and spacing right is skilled work, so an experienced bar bender is paid the skilled rate on most construction schedules.
A bar bender typically does cutting, bending and tying reinforcement steel to bar-bending schedules, work generally classified as skilled for minimum-wage purposes, so use the skilled category in the table above for the base rate. A supervisor or a specialised bar bender may sit a grade higher and must be paid more. Bar benders are commonly deployed at construction sites, infrastructure and precast yards.
Under the Code on Wages, the consolidated rate is re-fixed and adjusted for the cost-of-living index at prescribed intervals. The rates on this page are in force from 1 May 2026. For how Punjab structures and revises its rates in full, including every category and zone, see the Punjab minimum wages page.
What employers must do
- Pay every bar bender at least the notified minimum for their category and zone. Paying below it is an offence.
- Pay overtime at twice the ordinary rate for work beyond normal hours.
- Maintain a wage register, muster roll and wage slips, and pay within the wage period.
- Update payroll at each revision so no worker slips below the new minimum.
For staffing firms deploying bar benders across Punjab, keeping each worker on the right category and zone rate by hand is error-prone. ZeniaHR payroll checks every wage against the applicable state minimum automatically and handles the registers and PF/ESI returns. See also our statutory compliance software.
Related calculators
Work out the deductions on a Punjab wage with the in-hand salary calculator, the PF calculator and the ESI calculator.
Keep every worker on the right wage
ZeniaHR flags any worker paid below the applicable minimum and updates rates at each revision. Built for manpower and staffing firms.
Frequently asked questions
What is the minimum wage for a bar bender in Punjab?
A bar bender is generally classified as skilled, so the applicable minimum wage in Punjab is about ₹592.84 (per day). Confirm the exact rate for the zone and duties against the official notification.
Is a bar bender skilled or unskilled in Punjab?
For minimum-wage purposes a bar bender doing cutting, bending and tying reinforcement steel to bar-bending schedules is normally treated as skilled. Classification can vary with the exact duties and the scheduled employment, so always confirm against the official Punjab notification.
How often does the Punjab minimum wage change?
Under the Code on Wages, the consolidated rate is re-fixed and adjusted for the cost-of-living index at prescribed intervals. The rates on this page are in force from 1 May 2026.